OBD2 DVREDRSPORT HUDOBDII HUDOBD2 Dongle
Truck InterpreterTPMS HUDTPMS LED TPMS MotocycleTPMS ModuleTPMS Tool
SensorPioneer
Designed specifically for TOYOTA SIENNA
OBD2 Multi-Function HUD with TPMS
Part NO:EH1008
 
EH1008
Read  TPMS and vehicle data from OBD2.
Directly reading original equipped TPMS sensor, no need sensor ID learning and installation.
Real time monitoring 4 tires pressure and temperature in substitution the original car's insufficient information.
Display vehicle Speed, RPM, Throttle position, Battery voltage, Engine coolant temperature, Engine Load.
Plug & Play.
TOYOTA SIENNA 專用款,不用安裝胎壓傳感器,隨插隨用

OBD2 Multi-Function HUD    


         
Part NO:
EH1000: CAN & KWP2000 & ISO9141 ( TOYOTA, NISSAN CAN) protocol
              
CAN BUS Equipped vehicles LIST   
EH1030: J1850 ( GM&FORD) & ISO9141protocol
EHAT5000 ( or SC-EHAT1000) : EH1000 protocol with TPMS AT67 sensor
EHM5000 ( or SC-EHM1000) : EH1000 protocol with TPMS M30 sensor

Support CAN Bus /KWP2000 /ISO9141/J1850 communication.
Monitoring Engine Temperature, Speed, RPM, Fuel status, Battery voltage,...
Over Speed limit, High Temperature, Low voltage alert.
Head Up Display.
Easy to install, plug and play .

This Multi-Function Head-up-Display (HUD) plugs directly into your vehicle OBD2 port to reflect a host of vital engine data directly onto the windscreen from the dashboard - JUST AS IN THE LATEST TOP OF THE RANGE BMW (M5) & MERCEDES SPORTS CARS, and shows the driver the following information:
- Speed (SPD): Shown in RED
- Revs Per Minute (RPM): Shown in
RED
- Miles Per Gallon (MPG): Shown in
RED
- Selectable Display Value: Projected in
BRIGHT GREEN
- Engine Performance Indicator: Bar graph display in
INCREASING COLOUR RANGE
- Speed Limit Display (Selectable): THE ICON LIGHTS UP & ALSO SOUNDS AN AUDIBLE WARNING!
- Low Battery Warning: Numeric Display shows voltage when
its icon lights up.
- Temperature Abnormal Alert: Numeric Display shows engine coolant temperature when
its icon lights up.
- Throttle Position: Numeric Display shows throttle position ratio when
its icon lights up.

The HUD unit itself is very neat & compact (dimensions below) & available in two versions:
1. Head-up-Display ONLY (HUD)
2. Head-up-Display
incorporates with Tyre Pressure Monitoring System (TPMS)!

The TPMS comes with easy fit components to allow the HUD
showing the driver any abnormal warning from the tyres. By pre-setting the recommended tyre pressure threshold, each individual "TYRE ICON" will warn if a tyre is over inflated, deflated or its temperature is too high. This TPMS (Tyre Pressure Monitoring System) is achieved by RF (Radio Frequency) valve sensors fitted externally to each valve, & locked in place with the special tools to avoid tampering. So there is no need to remove the tyres for fitting, & the internal batteries are quick & easy to change.

Your vehicle must be OBDII/EOBD compatible. In Europe, EOBD was phased in between 2002-04 & from 1996 in the USA/Canada. Look at the under bonnet emission stickers to see if it says OBD2 or OBD II on your car. NB: MAY NOT WORK IF ORIGINAL ECU HAS BEEN UPGRADED OR ALTERED FROM THE
ORIGINAL MANUFACTURERS!

PLEASE NOTE: Because there are various OBD2 Protocols that vehicle manufacturers ,
the importance is not only that you first establish your vehicle is OBD2 Compliant, but you must also state the Make, Model & Year of you vehicle below, to assist us in providing the right HUD with the correct Protocol for your car!

The HUD is straightforward to install on your dashboard, requiring no specialist fitting, & comes with the following:
1. Installation Guide & User Manual
2. The HUD unit
3. Two Double sided sticker foam fixing strips
4. * Four External Fit Valve Sensors
5. * Four Valve Sensor Lock Nuts
6. * Special Valve Sensor Lock Nut Tools
7. * Four Valve sensor Internal Replaceable Batteries
8. OBD2 Port to HUD communication cable
9. Catoptrics Film- for ensuring visible windscreen display during daylight
* ONLY WITH THE VERSION WITH TPMS
*
Make sure you have a dashboard area in the desired "field of view"of at least 90mm x 62mm; the HUD footprint. The height of the HUD unit is approx. 20 mm.

More information

 

 

 

   
   
Copyright (C)2007 ATBS Technology Co. All rights reserved.